how can i see the FOP debug information?

julia · Post by **julia** » Fri Nov 19, 2004 11:47 pm

I'm a newbie. I'm using Oxygen 2.0.4 as my editor. I use the build-in Apache FOP as the processor and Xalan as the transformer. After I clicked the apply the transformation, the status bar shows in progress then FO transformation succesful. However I can't find the output PDF file on my disk. My collegue uses command line to help me do the transformation. He gets error message. How shall i configure the OXygen to let the debug information shown to me?

Post by **george** » Sun Nov 21, 2004 1:10 pm

Hi Julia,

You cannot do that in version 2.0.4. This is possible since version 3.0.

Best Regards,
George