DITA-OT output color space settings

Post here questions and problems related to editing and publishing DITA content.
Marty_McFly
Posts: 2
Joined: Tue May 23, 2023 12:01 pm

DITA-OT output color space settings

Post by Marty_McFly »

Hi, i'm using Miramo and DITA-OT, but unfortunately the colors in the output PDF do not match the ones defined in Miramo, so i guess there are some color space / color conversion shenanigans happening behind the scenes. Where should i go to set the right parameters? In short, i want the same RGB values for font colors in Miramo and the output PDF.
Thanks !
Radu
Posts: 8736
Joined: Fri Jul 09, 2004 5:18 pm

Re: DITA-OT output color space settings

Post by Radu »

Hi,
Maybe you should try to get in touch directly with Miramo as it's their product.

Regards,
Radu
Radu Coravu
<oXygen/> XML Editor
http://www.oxygenxml.com
Marty_McFly
Posts: 2
Joined: Tue May 23, 2023 12:01 pm

Re: DITA-OT output color space settings

Post by Marty_McFly »

Thanks, i'll try. I've just mentioned Miramo for the context but my hunch is that the issue comes more from DITA-OT settings. I'll try and contact them too.
Radu
Posts: 8736
Joined: Fri Jul 09, 2004 5:18 pm

Re: DITA-OT output color space settings

Post by Radu »

Hi,
In general if you are publishing from Oxygen, in the Oxygen Preferences->"DITA / Logging" page you can enable "Show console output->Always" and after publishing you will have a "DITA OT" console tab view at the bottom of Oxygen showing lots of logging information, including the command line and parameters which were used to start the DITA OT publishing engine.
Regards,
Radu
Radu Coravu
<oXygen/> XML Editor
http://www.oxygenxml.com
Post Reply