ViewViews Preferences
The ViewViews preferences page allows you to configure some options regarding certain views. To edit these options, and go to ViewViews.
The following options are available:
- Console section
-
- Enable Oxygen consoles
- If selected, various messages will be contributed to the Console view when certain events are triggered (such as schema detection, validation, or transformation events).
- Fixed width console
- If selected, a line in the Console view will be hard wrapped after the specified maximum numbers of characters allowed on a line is reached.
- Limit console output
-
If selected, the content of the Console view will be limited to a configurable number of characters.
- Console buffer
- If the Limit console output option is selected, this specifies the maximum number of characters that can be written in the Console view.
- Tab width
- Specifies the number of spaces used for depicting a tab character.
- Project view section
-
- Enable drag-and-drop in Project view
- Enables drag and drop support in the Project view. It should be disabled only if there is a possibility of accidentally changing the structure of the project by drag and drop actions.
- Information view section
-
- Maximum number of lines
- Specifies the maximum number of lines that can be written in the Information view.
- Elements view section
-
- Show only allowed items
- If selected, when editing in Author mode, only the elements that are allowed at the current cursor position will be listed in the Elements view. If not selected, all elements allowed by the schema will be listed, even if they are already used.