[oXygen-user] updated framework not used in conversion

[Oxygen XML Editor Support (Radu Coravu)]

Hi Lou,

Sorry but I don't know much about your setup.

Did you extend the TEI P5 framework in the "Document Type Association" 
preferences page and make modifications to it? Was it the framework 
which comes with Oxygen or the one installed via the update site from 
the TEI web site? Was your extension saved internal or to an external 
location?

About this remark:

> I note your comment below about ${frameworkDir} but this does not appear
> on the available list of editor variables; the default seems to be
> ${baseframeworkdir} : is that a synonym?

Usually an editor variable like "${baseframeworkdir}" can be used when 
you extend an existing framework. Such a variable resolves to the place 
where the base framework is located. Could you give me a screenshot with 
your entire application when the editor variables proposals drop down is 
show?

Regards,
Radu

Radu Coravu
<oXygen/>  XML Editor, Schema Editor and XSLT Editor/Debugger
http://www.oxygenxml.com

On 4/29/2015 5:54 PM, Lou Burnard wrote:
> Thanks Radu, that's very helpful. In fact, I had edited this
> transformation scenario, though not in the way it was referencing the
> ANT build file. I was working on a copy of the framework's default DOCX
> TEI scenario, which was looking for the ANT build file in ${frameworks}
>
> I note your comment below about ${frameworkDir} but this does not appear
> on the available list of editor variables; the default seems to be
> ${baseframeworkdir} : is that a synonym?
>
>
>     On 29/04/15 13:43, Oxygen XML Editor Support (Radu Coravu) wrote:
>> Hi Lou,
>>
>> You should try to edit the transformation scenario and see how it
>> references the ANT build file. Ideally it would refer to it using a
>> special editor variable which locates the latest TEI P5 installed
>> framework like:
>>
>>> ${frameworkDir(TEI P5)}/xml/tei/stylesheet/docx/build-to.xml
>>
>> If the transformation scenario is shown as read-only (and thus it's
>> defined at framework level) you can find the "TEI P5" document type
>> installed as an add-on in the "Document Type Association" preferences
>> page and you can edit the scenario in the "Transformation" tab.
>> All transformation scenarios defined at framework level should refer
>> to various resources using the "${frameworkDir}" editor variable in
>> order to be portable and self contained.
>>
>> Regards,
>> Radu
>>
>
> _______________________________________________
> oXygen-user mailing list
> 
> http://www.oxygenxml.com/mailman/listinfo/oxygen-user
>