[oXygen-user] Applying transform to files in project

[Eliot Kimber]

Ah, didn't realize the "Show as" was what puts the files in the message
area.

Cheers,

E.

On 1/31/12 8:28 AM, "Adrian Buza" <adrian at sync.ro> wrote:

> Hello Eliot,
> 
> You are correct in suspecting the results from the message area(results
> panel). To disable these and minimize the memory use during a
> transformation, edit the transformation scenario(Document ->
> Transformation -> Configure Transformation, Edit) and in the Output tab
> remove all the options from the "Show as" section(bottom): XHTML, XML, SVG
> 
> Let us know if the problem persists.
> 
> Regards,
> Adrian
> 
> Adrian Buza
> oXygen XML Editor and Author Support
> 
> Tel: +1-650-352-1250 ext.202
> Fax: +40-251-461482
> support at oxygenxml.com
> http://www.oxygenxml.com
> 
> 
> Eliot Kimber wrote:
>> I'm using the project view to apply a transform to many files. The resulting
>> files can be large and also include MathML.
>> 
>> I'm finding that after processing say 10-15 files, Oxygen reports out of
>> memory and starts to seize up.
>> 
>> I notice that the result files are being loaded in the message area, which
>> may be part of the cause.
>> 
>> Is this expected behavior? I would have expected the conversion to happen
>> but not to take up more memory than is required for a single transform
>> instance.
>> 
>> Cheers,
>> 
>> E.
>> 
>>  
> 

-- 
Eliot Kimber
Senior Solutions Architect
"Bringing Strategy, Content, and Technology Together"
Main: 512.554.9368
www.reallysi.com
www.rsuitecms.com