Oxygen XML Forum

In Oxygen 15, it would always show profiling attributes. When I upgraded to 16, I lost it and cannot make the setting stick. Each time I start Oxygen, I have to go to the my Profiling/Conditional Text menu and select Show Profiling Attributes. When I exit Oxygen and then open it up again, the setting is lost. Any ideas on how to make Oxygen always show profiling attributes?

Hi Susan,

The profiling conditions are saved related to the project which is opened in the Oxygen Project view.
It is possible that in your Oxygen 16.0 installation your Project view does not contain any active project. Just try to create a new project in the Project view and save it somewhere on your hard drive.
We'll try to make some changes on our side to avoid such a situation in a future Oxygen version.

Regards,
Radu

Hi,

Just to update this thread, in Oxygen 17 even if you do not have an opened project information about the applied profiling condition sets will still be saved.

Regards,
Radu