scenario parms from command line
Posted: Fri May 04, 2012 5:11 pm
Hi,
I've set the profile.condition (Docbook 5) parameter for graphics like this:
imageobject condition="print"
(or "web" for help) to set the scale value.
When I try building the PDF from the command line (using Saxon 6.5), I use the following:
-dprofile.condition=print
but the value is ignored. Graphics are all scaled to 100% which is not what I want.
My question is: how do I get Saxon to recognize scenario parameters?
I've set the profile.condition (Docbook 5) parameter for graphics like this:
imageobject condition="print"
(or "web" for help) to set the scale value.
When I try building the PDF from the command line (using Saxon 6.5), I use the following:
-dprofile.condition=print
but the value is ignored. Graphics are all scaled to 100% which is not what I want.
My question is: how do I get Saxon to recognize scenario parameters?