Page 1 of 1
DITA-OT output color space settings
Posted: Tue May 23, 2023 12:05 pm
by Marty_McFly
Hi, i'm using Miramo and DITA-OT, but unfortunately the colors in the output PDF do not match the ones defined in Miramo, so i guess there are some color space / color conversion shenanigans happening behind the scenes. Where should i go to set the right parameters? In short, i want the same RGB values for font colors in Miramo and the output PDF.
Thanks !
Re: DITA-OT output color space settings
Posted: Tue May 23, 2023 12:54 pm
by Radu
Hi,
Maybe you should try to get in touch directly with Miramo as it's their product.
Regards,
Radu
Re: DITA-OT output color space settings
Posted: Tue May 23, 2023 1:01 pm
by Marty_McFly
Thanks, i'll try. I've just mentioned Miramo for the context but my hunch is that the issue comes more from DITA-OT settings. I'll try and contact them too.
Re: DITA-OT output color space settings
Posted: Wed May 24, 2023 6:40 am
by Radu
Hi,
In general if you are publishing from Oxygen, in the Oxygen Preferences->"DITA / Logging" page you can enable "Show console output->Always" and after publishing you will have a "DITA OT" console tab view at the bottom of Oxygen showing lots of logging information, including the command line and parameters which were used to start the DITA OT publishing engine.
Regards,
Radu