Oxygen XML Forum

Hi All,

I am using Oxygen Author 20 with DITA 1.2

I have two Topics:

• Topic-1 and Topic-2

• Topic-1 has Figure-1

• Topic-2 has X-ref that says "See Fig-1"

Now in the book, I have two Maps.

• Map-1 uses Topic-1 and Topic-2

• Map-2 also uses Topic-1 and Topic-2

When I publish the Book:

• Map-1, Topic-2 cross-ref points to Topic-1 Fig-1 of Map-1. That is good

• But in Map-2, Topic-2 cross-ref also points to Topic-1 Fig-1 of Map-1

How can I make, Map-2, Topic-2 cross-ref point to Topic-1 Fig-1 of Map-2?
I know that Key & Keyref are applied at the Map level. And I do not have access to ScopeKey.

Is there any alternative at Topic Level, so reused content points to Topic in its own Map rather than pointing to Topic in other Map?

I hope you understand my question.

Thank you.

Hi,

Do you publish Map1 and Map2 individually or do you have a MainMap which refers both to Map1 and Map2, and you publish the MainMap?
I would understand things better if I would have a small sample DITA project to test.

Regards,
Radu

Hi,

I have MainMap (as a Book) which includes Map1 (as Chapter1) and Map2 (as Chapter2).

Map1 and Map2 both use same Topics (Topic1 & Topic1).

Hope this adds some clarity to your request.

I will prepare small sample for you but how do I attache it to this Post?
or should I just write XML Codes here?

Thanks.

Hi,

Our email address is "support@oxygenxml.com" if you want to send us small samples.

I think to make this work you would need to use DITA key scopes:
https://www.oxygenxml.com/dita/1.3/spec ... copes.html

For example the content of map1.ditamap would look like this:
and inside topic2.dita you would use a keyref to refer to the figure in topic1.dita: The content of map2.ditamap would be similar.

Regards,
Radu