How to see the unicode of a character in Oxygen editor
Posted: Fri Dec 08, 2017 5:03 am
Hi Oxygent expert,
One yahoo dita group member suggeted me to check the unicode of a character by
"Oxygen Editor shows the Unicode code point number on the status line (bottom of the window) for the character that is immediately after the cursor."
However, after I put cursor after a character, nothing shows either after the cursor or any information in the result windows.
Would you please share me how to check a character's unicode? I don't know how to make the status line shown in the bottom of the window.
Thanks!
Lisa
One yahoo dita group member suggeted me to check the unicode of a character by
"Oxygen Editor shows the Unicode code point number on the status line (bottom of the window) for the character that is immediately after the cursor."
However, after I put cursor after a character, nothing shows either after the cursor or any information in the result windows.
Would you please share me how to check a character's unicode? I don't know how to make the status line shown in the bottom of the window.
Thanks!
Lisa