[DOTA069F][FATAL] error during DOS batch processing
Posted: Mon Oct 16, 2017 9:12 pm
I'm trying to figure out why I publish html5 output from Oxygen 19.1, but not from a stand-alone installation of DITA-OT-2.5.2.
When run from DOS batch file, I get the following error message:
[Codebox=]Error: Failed to run pipeline: [DOTA069F][FATAL] Input file 'file:/C:/_working/build/DITA-OT-2.5.2/docsrc/samples/sequence.ditamap' cannot be located or read. Ensure that file was specified properly and that you have permission to access it.[/Codebox]
My batch file is the following:
and the properties file contains the following:
Research that I've done on [DOTA069F][FATAL] error revealed that perhaps the DTD could not be found during process. However, I opened the boomap in Oxygen and ran a validation check and it came back clean. I've no clue how to resolve this issue.
When run from DOS batch file, I get the following error message:
[Codebox=]Error: Failed to run pipeline: [DOTA069F][FATAL] Input file 'file:/C:/_working/build/DITA-OT-2.5.2/docsrc/samples/sequence.ditamap' cannot be located or read. Ensure that file was specified properly and that you have permission to access it.[/Codebox]
My batch file is the following:
Code: Select all
C:\DITA-OT-2.5.2>dita -i docsrc\samples\sequence.ditamap -f html5 -o=out\en\sequence -propertyfile=docsrc\samples\properties\sequence-html5.properties -d -v -l=log\sequence_html5.txt
Code: Select all
args.gen.task.lbl = YES
args.cssroot = C:\\_working\\build\\DITA-OT-2.5.2\\docsrc\\resources
args.css = dita-ot-doc.css
args.copycss = yes
args.csspath = css
nav-toc = full
args.xhtml.toc = toc