Page 1 of 1
Can I have 2 different WebHelp transformation scenarios?
Posted: Tue Dec 13, 2016 3:42 pm
by ann.jensen
Hi,
I have 2 transformation scenarios configured in oXygen Author which are customisations of the WebHelp Responsive scenario.
I want to configure different ditaval files for each in their
Filters tab. However every time I specify a ditaval file beside the
Use DITAVAL file: label for one it overrides the value for the other to be the same ditaval file
Am I missing something?
Thanks in advance,
Ann
Re: Can I have 2 different WebHelp transformation scenarios?
Posted: Wed Dec 14, 2016 2:51 pm
by radu_pisoi
Hi,
I cannot reproduce your problem using oXygen Author 18.1.
I've configured two transformation scenarios, each transformation scenario with its own DITAVAL file and output folder.
I did not find any problem in the WebHelp output folders after I run the transformation scenarios. Both WebHelp outputs were profiled accordingly.
Could you give us more details about your use case? What version of oXygen are you using?
Re: Can I have 2 different WebHelp transformation scenarios?
Posted: Thu Dec 15, 2016 12:44 pm
by ann.jensen
Hi Radu,
Ok, I see now what was happening. I selected one of my customised WebHelp transformations in the Configure Transformation Scenario(s) popup, set the ditaval file value and saved that scenario. I then deselected that scenario and selected my other customised WebHelp scenario and went to set its ditaval file value only to find it was set the same as my first scenario.
I didn't look up to see the name of the scenario that I was editing but the editor hadn't actually switched to the second scenario and I was still editing the first scenario. I have found that happening often if I don't wait a second or 2 between deselecting and selecting scenarios on the Configure Transformation Scenario(s) popup.
Regards,
Ann
Re: Can I have 2 different WebHelp transformation scenarios?
Posted: Thu Dec 15, 2016 12:47 pm
by ann.jensen
BTW I am using XML Author 18.1, build 2016102619
Regards,
Ann
Re: Can I have 2 different WebHelp transformation scenarios?
Posted: Thu Dec 15, 2016 7:06 pm
by adrian
Hi Ann,
I didn't look up to see the name of the scenario that I was editing but the editor hadn't actually switched to the second scenario and I was still editing the first scenario. I have found that happening often if I don't wait a second or 2 between deselecting and selecting scenarios on the Configure Transformation Scenario(s) popup.
We cannot reproduce this situation. Maybe there's a setting that triggers this.
Could you please provide a screenshot of the
Configure Transformation Scenario(s) dialog with your scenario selected? Please sent it to our support email address,
support@oxygenxml.com
Regards,
Adrian