Oxygen XML Forum

Hi again,

when I use DITA Map WebHelp Transformation, clean.output="yes" is not working. clean.temp="yes" works.

In "Parameter":
dita.temp.dir and output.dir are set and work - as far as I see.
In "Ausgabedatei" the value "Ausgabeverzeichnis" must be set and contains in my case the same value as output.dir.
Beside from the cleaning, everthing works fine - as far as I see.

Thank you,
Silke

Hi Silke,

The "clean.output" is not a parameter supported by default by the DITA Open Toolkit.
With Oxygen 17.1, the parameter should work only when used with the bundled DITA OT 1.8. So if you switched to DITA OT 2.x, indeed it does not work there. We plan to release Oxygen 18.0 in a couple of weeks and the parameter will also work with the DITA OT 2.x bundled with Oxygen 18.0.
If you are using your custom DITA Open Toolkit distribution, you will have to perform your own customization to support the parameter.

Regards,
Radu