Oxygen XML Forum

My colleagues both have PCs. I have a MAC. One of them created a DITA-to-Webhelp transform and it works fine on both PCs. It does not work on my MAC. I have altered the paths to match my structure, but I keep getting error messages that the build file can't find the target. However, the target is defined in the build file, so how can it not find it?

Any suggestions?

Thanks
Gillian

Hi Gillian,

I'm not sure what the problem might be because I do not know how that DITA to WebHelp transformation scenario was configured. Do you have the same Oxygen versions?
After the transformation fails, there is a "DITA OT" console view tab at the bottom containing all the logging received from the DITA OT ANT process. Maybe if you pasted it in your reply I could take a look at it.

Regards,
Radu

The log file says that it can't find a target referred to in the build file, but the target seems to be defined in the build file.

Hi,

Something may be misconfigured in the scenario that is not immediately apparent.

Please send us the full transformation output log from the DITA OT results panel.
If it's too large and you can't post it on the forums, please send it to our support email address, support@oxygenxml.com.

Regards,
Adrian