Oxygen XML Forum

When I run a DITA transformation, I only see a message in the status bar stating "Transformation in progress". When finished (even successfully) I get the Transformation problems window. I never see the DITA Transformation window appear during the whole process. Can someone please provide a way to show this again? I cannot locate it in any settings or menu command.

thanks!

Hello,

Starting with version 15.0 the DITA transformation console is only shown if the transformation fails (some users considered the information in it too technical).
To make the console visible, you need to edit the transformation scenario and in the Output tab check the "Show console output -> Always" option.

Let us know if you need further assistance.

Regards,
Ionela

Incredible... it was that simple. Thanks very much!!