[XSL-LIST Mailing List Archive Home]
[By Thread]
[By Date]
Hi David,
Thank you again for your reply, you helped a lot
Liron
----- Original Message ----- From: "David Carlisle" <davidc@xxxxxxxxx>
To: <xsl-list@xxxxxxxxxxxxxxxxxxxxxx>
Sent: Tuesday, February 21, 2006 6:10 PM
Subject: Re: [xsl] xsl:for - Only for existing nodes, how?
Re: [xsl] xsl:for - Only for existing nodes, how?
Subject: Re: [xsl] xsl:for - Only for existing nodes, how? From: "Liron" <magilam@xxxxxxxxxxxxxxxx> Date: Tue, 21 Feb 2006 18:16:57 +0100 |
Hi David,
Thank you again for your reply, you helped a lot
Liron
----- Original Message ----- From: "David Carlisle" <davidc@xxxxxxxxx>
To: <xsl-list@xxxxxxxxxxxxxxxxxxxxxx>
Sent: Tuesday, February 21, 2006 6:10 PM
Subject: Re: [xsl] xsl:for - Only for existing nodes, how?
Wouldn't it act just the same? I'm talking in a performance sense.
No, your solution tests that there is an item1 and if so outputs item1 and item2 (the latter may be empty) mine checked that there was an item 1 and an item2.
If you have
<control> <item1><data>x</data></item1> </control>
your solution would output x but mine would output nothing as there is no item2. I can't say which you need though.
David
Current Thread |
---|
|
<- Previous | Index | Next -> |
---|---|---|
Re: [xsl] xsl:for - Only for existi, David Carlisle | Thread | Re: [xsl] xsl:for - Only for existi, David Carlisle |
Re: [xsl] xsl:for - Only for existi, David Carlisle | Date | Re: [xsl] xsl:for - Only for existi, David Carlisle |
Month |