Editing a Transformation Scenario

Editing a transformation scenario is useful if you need to configure some of its parameters.
Note: You can edit transformation scenarios that are defined at project level only. To edit a transformation scenario that is associated with a predefined document type, duplicate it and edit the duplicated scenario.
To configure an existing transformation scenario, follow these steps:
  1. Select the Configure Transformation Scenario(s) (Ctrl + Shift + C (Command + Shift + C on OS X)) action from the toolbar or the Document > Transformation menu.

    Step Result: The Configure Transformation Scenario(s) dialog box is opened.

  2. Select the particular transformation scenario and click the Edit button at the bottom of the dialog box or from the contextual menu.
    Tip: You could also select the scenario and the Edit button in the Transformation Scenarios view to achieve the same result.

Result: This will open an Edit scenario configuration dialog box that allows you to configure various options in several tabs, depending on the type of transformation scenario that was selected.

Transformation Types

The Configure Transformation Scenario(s) dialog box contains a Type column that shows you the transformation type for each of the listed scenarios. Each type of transformation contains includes some tabs with various configuration options.

The following is a list of the transformation types and their particular tabs (click the name of each tab below to see details about all the options that are available):