[XSL-LIST Mailing List Archive Home]
[By Thread]
[By Date]
Re: [xsl] How to use generate-id() inside an xsl:function without a node available?
Subject: Re: [xsl] How to use generate-id() inside an xsl:function without a node available?
From: Abel Braaksma <abel.online@xxxxxxxxx>
Date: Wed, 28 Feb 2007 16:40:48 +0100
|
Andrew Welch wrote:
I'm sure Saxon used to generate consistent id's across transformation
runs along the lines of "d01e01" where d roughly meant document and e
meant element - I'm sure I used to rely (wrongly) on the consistency
and then had to create my own count after the algorithm changed -
somewhere around early version 7. There were also (iirc) some
conversations about how "d" couldn't be consistent if the document
came from a Stream... Maybe Abel's read those posts somewhere?
Perhaps I did, perhaps it was about the IS operator, I can't recall. But
thanks to you and Michael I have a clear picture now ;)
Cheers,
-- Abel
| Current Thread |
- RE: [xsl] How to use generate-id() inside an xsl:function without a node available?, (continued)
- Michael Kay - Tue, 27 Feb 2007 23:28:18 -0000
- Abel Braaksma - Wed, 28 Feb 2007 00:40:43 +0100
- Michael Kay - Wed, 28 Feb 2007 00:11:15 -0000
- Andrew Welch - Wed, 28 Feb 2007 09:45:13 +0000
- Abel Braaksma - Wed, 28 Feb 2007 16:40:48 +0100 <=
- Michael Kay - Tue, 27 Feb 2007 23:58:45 -0000
- Abel Braaksma - Tue, 27 Feb 2007 22:58:14 +0100
- Michael Kay - Tue, 27 Feb 2007 22:25:46 -0000
- Abel Braaksma - Wed, 28 Feb 2007 00:04:04 +0100
|
|